Before connecting the GPIB-USB interface to GPIB devices, ensure that the computer.Setting talker/listener GPIB address of E5071CThe 82357B USB/GPIB interface implements USB 1.1 (12 Mbits/s) and is compatible with USB 2.0.GPIB interfacing using Agilent 82357B on Ubuntu LinuxI initially had some problems installing on my laptop, so decided to boot Ubuntu 12.04.5 LTS, 3.13.0-32-generic from USB and work from there.For an automated installation script, see gpib_install.sh (and gpib.conf) below. In case of Windows XP, follow the following steps are required to set the USB/GPIB interface:Connect the USB port of the E5071C to the USB/GPIB interface.Select No, not this time, then click Next.Select Install the software automatically (Recommended), then click Next.The Found New Hardware Wizard appears again. Repeat the step 2 to 4 again.Select When a new 82357 is plugged in, then click OK.Select "When a new is plugged in." or "Never show this dialog" instead of "Each time a USB devices is plugged in".Changing the setting of the USB/GPIB interfaceIf you need to check/change the setting of the USB/GPIB interface after connecting the USB/GPIB interface, follow these steps:Press System key, then click Misc Setup > GPIB Setup > System Controller Configuration.The Keysight Connection Expert appears. (You can also execute Keysight Connection Expert from Task bar or Start menu in Windows.)Click Manual Configuration > Edit Existing Instruments/Interfaces.Change the setting of USB/GPIB interface.
0 Comments
Leave a Reply. |
Details
AuthorConnie ArchivesCategories |